How to clean industrial camera CCD?

 In order to prevent industrial camera CCD from aging quickly, Chengdu Xinxiwang will tell you how to clean industrial camera CCD below:

1. Shrink air cleaning

Under normal circumstances, compressed air is enough to remove all impurities inside the CCD industrial camera chip. However, spray-type compressed air is not recommended because the compressed air in sprays often contains water, oil and other substances that may damage the CCD surface.

2.Microfiber material

Microfibers can penetrate deep into the surface of CCD industrial cameras to remove impurities, thereby achieving cleaning purposes. 

3. Pure alcohol (concentration above 90%)

This material can be purchased at almost any chemical reagent store. But be careful not to use isopropyl alcohol, because isopropyl alcohol will absorb moisture in the air and leave liquid traces on the surface of the CCD industrial camera. 

4.Alcohol Substitutes

In addition to alcohol, methanol or a liquid called Eclipse can also be used to clean the surface of CCD industrial cameras. However, we do not recommend this method because methanol is a highly toxic substance. 

5. Comprehensive use of the above methods

The above methods can be combined to clean the surface of the CCD camera. If your fingers touch the glass on the front of the CCD, don't worry. This glass is very hard and will not leave scratches on its surface unless you use a glass knife, sand or diamond.